Action Result
Press any key to continue. The display shows:
Connect RSM
accessory
to the radio
(RSM connected)
Attach RSM accessory to the
radio.
The display shows:
RSM MIC to INT EAR
Loopback Test
(RSM connected)
Speak into the RSM micro-
phone.
You hear your voice from the internal earpiece.
30. Press the corresponding key to proceed to the next test.
Chopper Noise Test
31. Do the following:
Action Result
Press any key. The display shows:
Int MIC to internal earp
Place the internal earpiece close to your ear
and listen for Chopper Noise Test.
Make sure that the chopper noise is not audi-
ble.
Press any key. The display shows:
Connect RSM accessory to the radio
(RSM Connected)
Press any key. The display shows:
TOP Mic to RSM Chopper Noise Test
(RSM connected)
Bind around the antenna one binding of the
earpiece cable and place the external earpiece
close to your ear and listen for chopper noise.
Make sure that the chopper noise is not audi-
ble.
Press any key. The display shows:
Connect RSM accessory to the
radio (RSM connected)
Press any key. The display shows:
RSM MIC
to INT Ear Chopper Noise Test
Listen for chopper noise at the radio earpiece. Make sure that the chopper noise is not audi-
ble.
Press any key. The display shows:
Connect RSM accessory to the
radio (RSM connected)
Press any key. The display shows:
TOP Mic to RSM Chopper Noise
Test (RSM connected)
68015000841-EL
Chapter 4: Test Setup and Testing
59
To Next Page
Loading...
