10 Errors
Rev. 03/2019 165
10.3 Troubleshooting
10.3.1 Running a Self Test
You can run the self test via the MICT to check the order of the wiring and the connection
between the ignition controller outputs and the spark plugs. For this read section Self Test on
page 77.
Operational safety!
If you carry out a self test, it is essential for the gas supply to be switched
off and no more residual gas is left in the combustion chamber.
Non-compliance can result in damage to equipment or injury to persons.
10.3.2 Customer Service Information
You can reach our customer service during business hours at the following phone and fax
number, or by email:
Phone: +49 5141 93 99 0
Fax: +49 5141 93 99 99
Email: service@motortech.de
10.3.3 Returning Equipment for Repair/Inspection
To return the device for repair and inspection, obtain a return form and return number from
MOTORTECH.
Fill out the return form completely. The completely filled out return form guarantees fast,
uncomplicated processing of your repair order.
Send the device and the return form to one of the two addresses below or to the nearest
MOTORTECH representative:
MOTORTECH GmbH
Hogrevestr. 21-23
29223 Celle
Germany
Phone: +49 5141 93 99 0
Fax: +49 5141 93 99 98
www.motortech.de
motortech@motortech.de
MOTORTECH Americas, LLC
1400 Dealers Avenue, Suite A
New Orleans, LA 70123
USA
Phone: +1 504 355 4212
Fax: +1 504 355 4217
www.motortechamericas.com
info@motortechamericas.com
To Next Page
Loading...
Need help?
General
