Motortech MIC5 - Runtime Data - Message Log

8 Settings via the MICT
128 Rev. 03/2019
Status message Description
Temperature of device (x °
C
)
exceeded limit (y °C).
The temperature of the device (x °
C
) exceeded warning
threshold limit (y °C) for more than two minutes. Ensure
that there is sufficient air circulation and/or cooling.
Temperature of device (x °
C
)
exceeded permanent limit (y °C).
The temperature of the device (x °
C
) exceeded warning
threshold limit (y °C) for more than ten minutes. Ensure
that there is sufficient air circulation and/or cooling.
Temperature sensor failed. The temperature sensor has failed. Restart the ignition
controller. If the error occurs again after restarting the
device, please contact MOTORTECH.
8.12.6 Runtime Data – Message Log