5 Installation Instructions
Rev. 03/2019 35
5.3 Determine the Installation Location of the Pickup
Set the positions of the pickups depending on engine type and application. All angle reference
information is based on:
TDC 1st cylinder / compression cycle
The installation location for the pickups must have adequate mechanical strength and must not
exceed the specified temperature ranges. The pickups are designed for the appropriate use
only, multiple use of the pickup signal is not permissible. Ensure good accessibility to facilitate
the calibration of the sensor. Comply with the pertinent regulations for the wire routing.
For the exact positioning of the individual pickups, refer to the examples given in the drawings
(see section Input Wiring – Pickups on page 41).
To Next Page
Loading...
Need help?
General
