8 Settings via the MICT
94 Rev. 03/2019
8.11.4 Engine – Ignition Coils
Ignition Coil Type
Select the ignition coil type from the drop-down list. (Without this selection the configuration
cannot be downloaded to the MIC5.)
Only use measured ignition coils
To operate the MIC5, only ignition coil types measured by MOTORTECH may
be used. All ignition coils used must correspond to the part number
selected in the drop-down list. Different coil types must not be mixed and
also no equivalent or replacement types may be used.
If a coil type used is not in the drop-down list, then the MIC5 is currently not
used.