70 Rev. 03/2019
MICT is an abbreviation for MOTORTECH Integrated Configuration Tool. With the MICT, you can
configure your ignition controller, and you can view and adjust the operating data of your
engine. When working with the MICT, you can press the F1 key at any time to access context-
sensitive help.
If you are using a different version of the MICT than shown in the following sections, the scope of
functions may differ.
8.1 MICT System Requirements
For the installation of the MICT, the following minimum requirements must be fulfilled:
– x86-compatible PC, at least performance class Intel Pentium 4 with 2 GHz
– 128 MB free RAM
– 250 MB free disk space
– USB interface 1.1 or higher
– Display with a resolution of at least 1440 x 900 pixels (WXGA+)
– Microsoft
®
Windows 7, Windows 10
8.2 MICT Installation
The software for the installation of the MICT is on the storage device (USB flash drive or CD-ROM)
provided with the ignition controller.
To install the MICT, proceed as follows:
1. Start the installation:
– Via the menu:
Start the file Start.exe on the storage device. Start the installation routine of the MICT
via Software -> Install MICT.
– Directly from the storage device:
Start the installation routine of the MICT directly. It is on the storage device in the
subdirectory Installation and for example named as follows: MICT-2.0.0-setup.exe.
2. Run the installation.
Follow the instructions of the installation routine. Note that the license agreement terms
must be accepted before using the MICT.
3. Install the USB driver via the menu as well or directly from the storage device.
– Via the menu:
Software -> USB Drivers -> Install USB Drivers
– Directly from the storage device:
Start the exe file in subdirectory Drivers(e.g. CDM21226_Setup.exe).
The MICT is set up. You can connect your PC to the ignition controller via the USB
interface.
8 Settings via the MICT
To Next Page
Loading...
Need help?
General
