8 Settings via the MICT
Rev. 03/2019 83
5. Confirm the input with OK.
All PINs are now reset to the value 0000.
To reset all PINs, you need the PIN for the level Master (level 3). To be able to unlock a system in
case of emergency that was locked in this way, you have the following option:
1. In the menu bar, select the entry Device -> Access Control -> Get reset all PINs request key to
open a window with the same name.
2. Send the request key with the serial number to your service contact person at MOTORTECH
(refer to Customer Service Information on page 165). This key is valid only for the respective
controller and only for a certain amount of time.
Your information will be verified, and you will receive an authorization key from your
contact person.
3. From the menu bar, select the entry Device -> Access Control -> Set reset all PINs
authorization key to open a window with this name.
4. Enter the authorization key received in the input field.
5. Confirm the input with OK.
If the input was correct, all PINs are reset to the default value 0000.
8.10 Working with Configurations
To ensure that the MIC5 correctly interprets incoming data and correctly controls the ignition
system, it requires information about the engine and the ignition system. This information is
stored in the MIC5 as configuration data.
You can use the MICT to perform the following for these configurations:
– Create
– Open
– Edit
– Save as a file
– Download to the MIC5
– Upload from the MIC5
To Next Page
Loading...
Need help?
General
