7 Functions
68 Rev. 03/2019
7.12 Ignition Energy
The ignition energy can be set separately for the start phase and normal operation. Here
different settings can be made for schedules A and B.
You can configure the ignition energy with the MICT. Please refer to the section Timing –
Schedule A/B – Energy on page 104.
7.13 Access Control
The MIC5 has four operating levels, three of which can be secured with different PINs. As a
default setting, the access control is not activated. If the access control for the MIC5 is activated,
it is independent from the access levels that control authorizations within the MICT.
Access control in the MICT and on MIC5
A user is logged in to the Advanced Service access level on the MICT. He
changes a configuration and would like to download the change to the
MIC5. Although he has the full authorization set in the MICT, he is prompted
to log in with the PIN for the Level 3 (Master) on the MIC5.
A variety of functions are at your disposal in the four operating levels of the MIC5 . The figure
below illustrates this:
To Next Page
Loading...
Need help?
General
