MR ETOS ED - Page 51

4 Product description
Maschinenfabrik Reinhausen GmbH 2020 516385142/08 EN ETOS
®
ED
In these operating instructions, the path for navigating to a parameter is al-
ways shown in an abridged form: Go to Settings > Parameters > System >
Time synchronization.
Setting parameters
There are various ways to configure the settings, depending on the parame-
ter.
Selecting from a list To select a list entry, proceed as follows:
1. Use the rotary knob to navigate to the list and press the key.
Figure32: Select an entry from a list
2. Use the rotary knob to highlight the list entry and press the key.
3. Press the Accept button to save the modified parameter.