MUTOH ValueJet 1304 - Page 67

User’s Guide ValueJet 1304
Handling the printer
AP-75780 - Revision 1.3 67
4
Initial change menu
Sets up Initial Adjust change.
Confirm Print menu
Performs confirm print
Micro Print menu
Performs micro adjustment print
Setup item Settings Description
Init.
200.0 mm to <250.0
mm> to 300.0 mm
Sets up the initial adjust change
---
 ENTER: saves the setting and shifts to the
previous menu.
 CANCEL: Cancels the setting and shifts to
the previous menu
Refer to:Dist.Adj menu on page66
Setup item Settings Description
FeedLength
100 mm to <250 mm>
to 500 mm
Changes the length of the media feed
direction for the confirm print.
 ENTER: determines the setting. “Printing”
is displayed and initial adjust print starts.
After printing, the printer enters the
Normal state.
---
 ENTER: saves the setting and shifts to the
previous menu.
 CANCEL: Cancels the setting and shifts to
the previous menu
Refer to:Dist.Adj menu on page66
Setup item Settings Description
Micro print
Printing
Prints the following PF pattern with a focus
on the micro adjustment value.
Printing interval 1min
---
 CANCEL: shifts to the previous menu.
Stops printing and returns to the
previous menu if printing is in progress.
Refer to:Dist.Adj menu on page66