MUTOH ValueJet 1304 - Page 68

User’s Guide ValueJet 1304
Handling the printer
68 AP-75780 - Revision 1.3
Micro Change menu
Sets up Micro Adjustment Change
Pre heater menu
Sets up the Pre heater temperature.
Set up to preheat the media before printing and insulate the temperature change in the printer
section.
Setup item Settings Description
Micro Change
- 20 pulse to <0
pulse> to 20 pulse
Sets up Micro Adjustment Change
---
 ENTER: saves the setting and shifts to the
previous menu.
 CANCEL: Cancels the setting and shifts to
the previous menu
Refer to Dist.Adj menu on page66
Note
 Preset temperature of Pre Heater varies depending on the media.
Setup item Settings Description
Pre Heater
OFF/ <30°C> to 50°C
Sets up the pre heater temperature.
1 = Roll media
2 = Pre Heater
3 = Print head
---
 ENTER: saves the setting and shifts to the
previous menu.
 CANCEL: Cancels the setting and shifts to
the previous menu
Refer to: User media menu on page63