Panel setup menu VJ-1628X OPERATION MANUAL
250 5.3 Cleaning menu
5.3 Cleaning menu
Performs head cleaning.
Head cleaning can be operated when the printer is Normal.
Refer to the following for operation procedures.
6.4.3 Head cleaning
• If the head height is set to High, "Change Head Gap Low" is displayed on Operation panel.
Set the head height to Low.
4.2.5.3 When setting the head height to Low
Setup item Description Description
Short — Discharges smaller amount of ink compared to “Normal”.
• [Enter] key:
“Cleaning **%” is displayed on Operation panel and head cleaning starts.
Progress on the Head cleaning is displayed in % on Operation panel.
Normal — Select this mode normally.
• [Enter] key:
“Cleaning **%” is displayed on Operation panel and head cleaning starts.
Progress on the Head cleaning is displayed in % on Operation panel.
Long — Discharges larger amount of ink compare to “Normal”.
Used when Print head does not improve by normal head cleaning.
• [Enter] key:
“Cleaning **%” is displayed on Operation panel and head cleaning starts.
Progress on the Head cleaning is displayed in % on Operation panel.
Little Charge — Refills a small amount of ink.
Charge a small amount of ink when printing is not stable after ink replenishment.
3.4 Filling ink
• [Enter] key:
“Ink Refill **%” is displayed on Operation panel and ink replenishment starts.
Progress on the ink replenishment is displayed in % on Operation panel.
Initial ink charge — Performs the initial ink charge.
Even when using the printer whose ink has already been filled, when you use High-
capacity ink pack adapter for the first time, perform this initial ink charge.
3.4.6 When using High-capacity ink pack adapter for the first time on
the printer whose ink is filled
• [Enter] key:
“InitialCharge: Start” is displayed on Operation panel
Start [Enter] key:
“Ink Refill **%” is displayed on Operation panel and ink replenishment starts.
Progress on the ink replenishment is displayed in % on Operation panel.
— — • [Cancel] key: shifts to the previous menu.
5 Panel setup menu