Troubleshooting VJ-1628X OPERATION MANUAL
332 7.2 Error messages
7.2 Error messages
This section describes messages displayed during normal printer operation or when errors occur, and
solutions to the messages.
7.2.1 Status messages
This section describes messages displayed during printer normal operation.
When the printer is operating correctly, each operation status is displayed on Operation panel as below.
No. Display Description Reference
1 Ready to Print Standby (Media is loaded). —
2 Media End Standby (Media is not loaded).
3.5 Loading
media
3 Receiving Receiving data. —
4 Analyzing data Analyzing data. —
5 Printing Under printing. —
6 PrintRestart --> ENTER Pausing printing.
Press the [Enter] key.
4.4.6 Pausing
printing
7 Warming Up Warming up Heater. —
8 Warming Up
Skip -> Enter
Received the printing data while Heater is
warming up.
To start printing before Heater is warmed up,
press the [Enter] key.
4.4.7 Starting
printing during
warming up
9 Cleaning **% Cleaning the head.
Please wait a while.
6.4.3 Head
cleaning
10 Ink Refill **% Filling the ink.
Please wait a while.
• The timer
has been set.
11 Moving Origin Pos. Print head is moving to the original printing
position in the Origin menu.
Please wait a while.
5.1.7.1 Cut
Pressure menu
12 Confirm Position -> Enter Print head is moving to the original printing
position in the Origin menu.
Press the [Enter] key.
5.1.7.1 Cut
Pressure menu
13 During Washing Cleaning Head.
Please wait a while.
5.1.19
Longstore menu
14 Remove Cartridges Perform head cleaning.
Remove Cartridge.
5.1.19
Longstore menu
15 ** Initializing ** Initializing the setting in the Initialization
menu.
Please wait a while.
5.1.21
Initialization menu
16 Power Off Turning the printer off.
Please wait a while.
Do not unplug Power cord set till Operation
panel is turned off.
3.2.2 Turning
the power OFF