VJ-1628X OPERATION MANUAL Maintenance
6.5 Disposal of waste fluids 317
6.5 Disposal of waste fluids
The timing and method for the disposal of waste fluid are described below.
(1) Disposal timing
Dispose of waste fluids in the following cases:
a. When Waste fluid tank is more than half full.
b. When “Full WasteInkTank” is displayed on Operation panel.
(2) Disposal method
Follow the procedure below to dispose of waste fluid.
• You are obligated to properly dispose of waste fluid from the printer in compliance
with Wastes Disposal and Public Cleansing Act and local ordinances.
Delegate disposal to an industrial waste disposal contractor.
1. Ready an empty container such as a supply waste fluid bottle, to contain the waste fluid.
2. Lay a protective material, such as waste media, on the floor under Waste fluid tank.
3. Open the waste fluid valve, and transfer the waste fluid to the container.
• When transferring the waste fluid to the empty container, the waste fluid may spatter.
Make sure to put the container close to the waste fluid valve.
No. Name
1 Waste fluid valve
2 Empty container
To Next Page
Loading...
Need help?
General