Maintenance
5‐9
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Changing Lubricant
NOTE: Drain lubricant when warm.
Remove the gear box from the motor to change lubricant:
1. Stand the motor on edge such that the gear box faces down. Brace the
gear box on the flange for stability.
2. Remove the screws connecting the gear box to the motor.
3. Use a sharp chisel to separate the motor from the gear box.
Shown rotated 90°
1
.
Fig. 5‐5 Example
4. Detach the motor from the gear box.
5. Drain the lubricant.
NOTE: Properly dispose of the old lubricant according to local
regulations.
6. Wash out casing with suitable cleaning agent and remove lubricant
residue.
7. Clean the mounting surfaces.
8. Measure the correct amount of the right lubricant and pour it into the gear
box. The lubricant quantity is indicated on the motor ID plate. Do not
overfill!
9. Apply a continuous sealing bead of Teroson MS939 (or similar lubricant)
to the gear box sealing surface. Also encircle the connecting screws and
centering pins with lubricant.
10. Align the bevels and aligning pins and allow the motor to glide onto the
gear box. Insert all connecting screws and tighten crosswise.
11. Remove excess lubricant.
To Next Page
Loading...
