Fig. 2‐8
Plate
Introduction
2‐10
P/N 213828_11
2014 Nordson Corporation
VersaBlue_PPA
Pressure Display / Pressure Control (Options)
The sensing elements for the pressure sensors (1b) for material outlet
pressure are located in the manifold (arrow).
The pressure sensor measuring transducers (1a) are located on the plate
below the manifold.
1a
1b
Pressure Display
The melter outlet pressure is displayed and monitored. Alarms for
underpressure and overpressure are displayed.
Pressure Control
One pressure sensor per pump. There is no pressure control valve.
The desired pressure is set on the control panel. The pressure sensor
converts the pressure to an electrical signal, which is used for control via the
CAN bus.
To Next Page
Loading...
