Nordson VersaBlue VA - Operation; General Information; Channel Numbers; On the Control Panel

Ch5: Temperature sensor short-circuit
Alarm
history
Fig. 4‐1
Alarm log
Operation
4‐1
P/N 213828_11
 2014 Nordson Corporation
VersaBlue_PPA
Section 4
Operation
ATTENTION: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions here and in the entire documentation.
General Information
IPC Corresponding software version
Generation II ≥4.00.000 AND <6.00.000
Generation III ≥6.00.000
The control panel is a touch screen.
The date is shown in the following format: YYYY-MM-DD
(Y: year; M: month; D: day)
The melter can also be operated via the Webserver. The user interface is the
same as the control panel. Refer to Operation via the IPC Webserver at the
end of this section.
Channel Numbers
On the Control Panel
The numbers of the temperature channels shown on the control panel (alarm
lists and setpoints) are a factor of the settings made by the operator.
Ch5 (Channel 5): If a group contains at least one channel, the channel
number refers to the number below the channel symbol (arrow). To
determine the current channel numbers, refer to the screen Define Groups on
the control panel of the relevant melter.
Channel Ch5 (when part of
a group)
Channel Ch5 (when not part of
group), if at least one other
channel belongs to a group
Channel Ch5 (when not part of a
group), if no other channel
belongs to a group
B5
3
5
3
5
5