Nordson VersaBlue VA - Replacing Filter Cartridge; Observe When Performing Work Behind Electrical Equipment Cover; Replacing Thermostat

1
2
Fig. 7‐26
1
2
3
Fig. 7‐27
Repair
7‐18
P/N 213828_11
 2014 Nordson Corporation
VersaBlue_PPA
Replacing Filter Cartridge
Proceed as described in section Maintenance to replace filter cartridge.
Observe when Performing Work behind Electrical
Equipment Cover
ATTENTION: The electrical cover (1) is linked to ground conductors. The
ground conductor (2) must be reconnected after every repair.
Replacing Thermostat
1. Remove electrical equipment cover.
2. Release fixing screws and remove the old thermostat (see arrows).
3. If necessary, clean the fastening point with a lint-free cloth.
4. With older melters VT, the adapter plate (1, Fig. 7‐27) may need to be
placed between the tank and the high temperature thermostat
(2, Fig. 7‐27).
5. Attach connecting wires to the new thermostat.
6. Apply heat transfer compound to the bottom of the thermostat (Refer
toProcessing Materials in the section Maintenance), then fasten it to the
tank again.
CAUTION: Ensure that the flat receptacles (3, Fig. 7‐27) do not touch the
side of the tank.
7. Attach the electrical equipment cover again.