Nordson VersaBlue VA - Daily Startup

Automatic heatup upon
melter start
Maximum temperature setpoint
Operation
4‐26
P/N 213828_11
 2014 Nordson Corporation
VersaBlue_PPA
Daily Startup
NOTE: The following steps can be performed completely only with a level
1 password or, for basic settings, with a level 3 password.
Enter password
The key that triggered the password input prompt must be touched again
after the correct password has been entered. The level that corresponds to
the password entered is enabled for 10 minutes.
When the material is changed, keep in mind that the setpoint temperatures
may need to be adjusted.
1. Set the main switch to I/ON. The melter begins to heat up.
EXCEPTION: If the seven-day clock is enabled and the melter is
switched on, heatup does not begin automatically.
Software version 6.00.000 and higher
The new key allows the melter to be switched on without the heaters being
automatically switched on (password level 3).
Touch key. Automatic heatup upon melter start blocked causes, when the
melter is switched on the next time:
1. Set the main switch to I/ON. The melter does not begin to heat up until
the command is given.
Automatic heatup upon melter
start - default
+ (Seven-day clock OFF) Melter heating
+ (Seven-day clock ON) Melter not heating
Automatic heatup upon melter
start blocked
+ (Seven-day clock OFF) Melter not heating
+ (Seven-day clock ON) Melter not heating
Automatic heatup upon melter start