NXP Semiconductors MKL25Z128VLK4 - Global Pin Control High Register (Portx_Gpchr); Interrupt Status Flag Register (Portx_Isfr)

PORTx_GPCLR field descriptions (continued)
Field Description
0 Corresponding Pin Control Register is not updated with the value in GPWD.
1 Corresponding Pin Control Register is updated with the value in GPWD.
15–0
GPWD
Global Pin Write Data
Write value that is written to all Pin Control Registers bits [15:0] that are selected by GPWE.
11.5.3 Global Pin Control High Register (PORTx_GPCHR)
Only 32-bit writes are supported to this register.
Address: Base address + 84h offset
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0 0
W
GPWE GPWD
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
PORTx_GPCHR field descriptions
Field Description
31–16
GPWE
Global Pin Write Enable
Selects which Pin Control Registers (31 through 16) bits [15:0] update with the value in GPWD.
0 Corresponding Pin Control Register is not updated with the value in GPWD.
1 Corresponding Pin Control Register is updated with the value in GPWD.
15–0
GPWD
Global Pin Write Data
Write value that is written to all Pin Control Registers bits [15:0] that are selected by GPWE.
11.5.4 Interrupt Status Flag Register (PORTx_ISFR)
The corresponding bit is read only for pins that do not support interrupt generation.
The pin interrupt configuration is valid in all digital pin muxing modes. The Interrupt
Status Flag for each pin is also visible in the corresponding Pin Control Register, and
each flag can be cleared in either location.
Address: Base address + A0h offset
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
ISF
W
w1c
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Memory map and register definition
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
186 Freescale Semiconductor, Inc.