Oce VarioStream 7000 SINGLE - Page 129

5.6.3 Input at the operator panel
A29246-X20-X-4-7680 / fa505.fm 129
• Increasing the fusing temperature:
A waiting period follows automatically during which printing is not possible.
• Lowering the fuser temperature
– by one stage:
Printing can begin immediately.
– by more than one stage:
A waiting period of five minutes is necessary. If this waiting period is too long, you can
instead press the EJECT key, to advance blank pages for one minute.
• Selecting fuser oil quantity:
• Setting the paper brake:
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• Menu <VarioStream> <Configuration> <Print parameters> <Fusing quality>
3. Select the desired fuser oil quantity under "Oiling".
4. Click on the following button:
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
1 of 2