Oce VarioStream 7000 SINGLE - Page 128

5.6.3 Input at the operator panel
128 A29246-X20-X-4-7680 / fa505.fm
The values for the following settings must be determined by test runs with the paper being
used.
• Changing the fusing temperature:
2. On the operator panel select:
• Menu <VarioStream> <Configuration> <Printing system> <Paper path>
3.
• If using light or normal paper:
select the "Calibrator" checkbox with a mouse click.
• If using light or normal paper:
deactivate the "Calibrator" checkbox with a mouse click.
4. Click on the following button:
Important
The printing system needs a certain amount of time to reach the new temperature.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• Menu <VarioStream> <Configuration> <Print parameters> <Fusing quality>
3. Select the desired temperature under "Fusing temperature".
4. Click on the following button:
Proceed as follows:
2 of 2