7.2.1 Replacing the toner bottle
A29246-X20-X-4-7680 / fa701.fm 227
The printing system detects the end of the toner supply automatically and displays a
warning on the operator panel in good time.
The following procedure is for replacing the toner bottle:
- Removing the toner bottle >>> page 227
- Installing the toner bottle >>> page 229
Removing the toner bottle
Important
• Only use toner that is suitable for the developer being used (see section
Consumables, page 356).
• Only refill with original, sealed toner bottles secured by an intact seal.
• Do not re-use toner.
• Always store toner in a cool (< 35
o
C), dry and well ventilated room.
• Never expose toner to direct heat (sunlight, heaters, etc.)
Caution
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber
nozzle and filter set for fine dust. For larger quantities of toner spill (e. g. full bottle),
the industrial vacuum cleaner must be explosion-proof.
Proceed as follows:
1. If the printing system has not yet stopped, click the following button:
2. On the operator panel select:
• Menu <Replace consumables> <Replace toner bottle>
1 of 3
To Next Page
