Station 1 ID Intake Fan
Figure 5-2
5.3.2.4 Motor and clutch test
The motor and clutch test is used for testing motors and clutches.
1. Enter the self-diagnostic mode (level 1) and, until “MOTOR & CLUTCH TEST”
appears on the upper display, press the MENU
or MENU button (the
MENU
button displays the next test option and the MENU button displays the
preceding test option). Then press the OK button.
2. Press the MENU
or MENU button until an option shown in table 5-5 for the
unit to test appears on the lower display (the MENU
button displays the next
option and the MENU
button displays the preceding option).
MotoR & cLUtcH test
6,'02725
3. Press the OK button. The motor and clutch test starts, the unit’s the name and
current status starting to blink, and the unit being driven for ten seconds (refer to
figure 5-2).
Note! The state in step 2 is restored after the unit is driven for 10 seconds. The unit
is driven again by pressing an appropriate button.
• The motor keeps running if holding down not the OK button but the ON
LINE button. to determine the motor.
• By usual printing driving, the clutch solenoid repeatedly is turned on and off
(its motor is driven together with the solenoid when the solenoid cannot be
driven solely for its mechanical structure).
* “ID UP/DOWN” and FUSER RLS” , "TR2 POS ADJUST"continue until the
CANCEL button is pressed.
4. Press the CANCEL button. The state in step 2 is restored. (The display of the
corresponding unit is maintained.)
5. Repeat steps 2 through 4 when necessary.
6. Press the BACK button to end the test (the state in step 1 is restored).
To Next Page
Loading...
Need help?
General
