Oki C911 - LED Head

45530603TH Rev.2
6-11
Oki Data CONFIDENTIAL
6. REPLACEMENT OF PARTS
6.2.7 LED Head
(1) Detach the Image Drum and Belt Unit.(Refer to section 6.2.2 and 6.2.3)
(2) Remove the Cover-Assy-Front.(Refer to section 6.2.18)
(3) Put up these left and right remainded hinges, and put down the LED Head
①
.
(4) Unlock the connector of back side.
Note! Unlock the connector when disconnect and connect. If not, break the FFC
terminal.
Lock Lever break away easy, carefully when remove.
(5) Warp the claw of front side and remove the front side of LED Head
①
.
Warp
(5)-1
(5)-2
(5)-3
(6) Detach the claw of front side and disconnect the FFC to remove LED Head
①
.
Claw of connector
(6)-1
(6)-2
Note! The FFC is fragile, therefore carefully to remove.
Lock (Lever : down) Unlock(Lever : Up)