Oki C911 - Board-F1 G(Tag Terminal PCB); Board-F1 N(Toner-Low Sensor PCB)

45530603TH Rev.2
6-27
Oki Data CONFIDENTIAL
6. REPLACEMENT OF PARTS
6.2.34 Motor-Assy-Geard
(1) Remove the Frame-Assy-TC and Frame-Assy-TC-R.(Refer to section 6.2.31)
(2) Remove the two screws(black)(8mm)
①
and remove the Geard-Motor
②
.
(3) Remove the two screws(black)(8mm)
③
and remove the Geard-Motor
④
.
②
①×2
④
③×2
6.2.33 Board-F1H(Print head power relay PCB) /
Board-MFH(Environmental sensor PCB)
/ Board-F1G(Tag terminal PCB) / Board-
F1N(Toner-low sensor PCB)
(1) Remove the Frame-Assy-TC and Frame-Assy-TC-R.(Refer to section 6.2.31)
(2) Remove the screw(silver)(6mm)
①
and remove the Board-MFH
②
.
(3) Remove the four screws(silver)(6mm)
③
and screw(silver)(8mm)
④
and remove
the Plate-Assy-Top
⑤
.
(4) Remove the screw(black)(8mm)
⑥
and remove the Board-F1G
⑦
.
(For C941 : five, for C911/C931 : four)
(5) Remove the screw(black)(8mm)
⑧
and remove the Board-F1H
⑨
.
(6) Leave two latch and remove the Board-F1N
⑩
.
④
⑥
×5
③×4
⑤
⑧
①
⑨
②
for C941 only
⑩×5
⑦
×5