45530603TH Rev.2
5-16
Oki Data CONFIDENTIAL
5. MAINTENANCE MENUS
(1) Menu option display switching
The level in a shaded area
XXXXX
can be displayed only from another one.
Use the MENU
or MENU button to display the menu option shown in a
non-shaded area
XXXXX
.
Self-diagnostic
mode layout
(Overall)
LEVEL0- engine status display
Engine status display
Each voltage display category in
printing
To ne r se n s or mo n i to r
To ne r pu l se c ou n t m o ni t o r
Consumable tag noise test monitor
Motor control evaluation function
Error code
POWER ON
Normal operation mode
OK
OK
No buttons pressed
Press the BACK, OK and ON LINE combination after “Ready”
is displayed until System Maintenance menu appears, and
select Engine Diag Mode and press OK.
BACK
5.3.2 Self-diagnostic mode
Image Drums, and, these motors and sensors concerned with each image drum are
named to [Station] in this section (non-used color name). These Stations set 1 to 5 in one
by one in order from upstream-side to downstream-side of at transportation direction of the
intermediate transfer belt.
In this section, these are used '[Station1] to [Station5]' or '[S1] to [S5]' as following figure.
For the 4-color model, [Station1] arrenged at most upstream-side in above direction is not
used. Therefore, the 4-color model is constituted by from [Station2] to [Station5].
LEVEL 1
DIAGNOSTIC MODE XX.XX.XX
-MODE
SWITCH SCAN
MOTOR CLUTCH TEST
TEST PRINT
REG ADJUST TEST
DENS ADJUST TEST
MEDIA WT ADJUST PA
PA PE R W I DT H SN S AD J
CONSUMABLE STATUS
PRINTER STATUS
FAC TORY MODE SET
SENSOR SETTING
LED HEAD DATA
DRUM MANUAL CLEANING
or S2
Station1
or S1
Belt creaning blade
Waste toner box
5.3.2.1 Operation panel
The following description on operating the self-diagnostic is provided, premised on the
following operation panel layout:
This section describes LEVEL 0 and LEVEL 1.
To Next Page
Loading...
