Oki C911 - Page 72

45530603TH Rev.2
4-27
Oki Data CONFIDENTIAL
4. TROUBLESHOOTING PROCEDURE
LCD Status Message
( represents a blank line.)
Online
indicator
Inspection
lamp
Details
Remedial
measure
%COLOR% Toner
Low
Varies On
(Blink)
Off
Indicates that amount of toner is low.
When the MENU button > [Menus] >
[System Adjust] > [Low Toner] is set to
[Stop], the inspection LED blinks, and
the printer goes into offline.
When the OK button is pressed, or
when a specific error is cleared, the
printer exits the offline mode and
continues printing until TONER EMPTY
is detected.
A specific error is one of errors from
Priority 300 to 380.
If a TONER LOW error has occurred
when the power is turned on and also
the MENU button > [Menus] > [System
Adjust] > [Low Toner] is set to [Stop], the
inspection LED blinks, a beep sounds,
and the printer goes into offline at the
timing when initialization is completed.
By pressing the OK button, the printing
can continue until TONER EMPTY is
detected.
When [Admin Setup] > [Panel Setup] >
[Near Life LED] is set to [Disable], the
inspection LED stays out.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
–
Non OEM
%COLOR% Toner
Detected
Varies On Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
Prompts
the user
to use an
optimal
toner
cartridge.
LCD Status Message
( represents a blank line.)
Online
indicator
Inspection
lamp
Details
Remedial
measure
Incompatible
%COLOR% Toner
Varies On Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
Prompts
the user
to use an
optimal
toner
cartridge.
Non Genuine
%COLOR% Toner
Varies On Indicates detection of a toner cartridge
not suitable for this printer.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
Prompts
the user
to use an
optimal
toner
cartridge.
%COLOR% Image
Drum Sensor Error
Varies On Something is wrong with the toner sensor.
%COLOR%
Yellow
Magenta
Cyan
Black
White
Clear
This warning message is displayed
only in the Shipping mode. Alternatively
an error from 5400 to 5405 may
appear depending on the PU detection
conditions. In the Factory mode, a
service call from 163-01 to 163-05
appears instead.
If the image
drum is
fixed with
a stopper,
remove it.
Lightly wipe
the image
drum
sensor lens
surface
with a dry
soft tissue.
Non Paper Sense
Error
Varies On The sensor output value at paper out is
out of spec. (zero point correction error).
When this error occurs, execute printing
by setting Media Weight to Medium.
–
Paper Sense Error
Varies On The sensor output value difference
is out of spec. (thickness beyond the
detection limit).
When this error occurs, execute printing
by setting Media Weight to Medium.
–