DMTA-20015-01EN [U8778402], Rev. J, January 2014
Basic Operation
87
8. Basic Operation
This chapter describes the basic principles and procedures involved in operating the
OmniScan MX.
8.1 Turning On and Off the OmniScan MX
To turn on the OmniScan MX
In order to prevent injury, do not place your fingers between the acquisition module
and the instrument’s support stand (when unfolded).
Press and hold the Power key ( ) for one second.
The system starts up, performs a memory check, and displays the OmniScan logo
and software version number. If there is more than one application installed on
your instrument, each application will be displayed on one of the buttons
appearing on the OmniScan splash screen. Choose the desired inspection
application by pressing the “
F” (Parameter) key corresponding to the appropriate
button.
To Next Page
Loading...
