CT Analyzer User Manual
142 OMICRON
10 Using the Quick Test feature
Quick Test is an optional feature. The functionality described in this chapter is only available if you have
purchased a corresponding license. For further information, please contact your OMICRON sales
contact or the OMICRON office nearest you.
The Quick Test feature cannot be used when a CT SB2 switch box is connected to the remote
control interface of CT Analyzer.
Measurements using Quick Test are not automatically stopped by CT Analyzer. Such
measurements have to be stopped manually.
CT Analyzer possibly switches off its output automatically after a long period (> 15 min) of continuous
operation at its maximum output power to prevent thermal overload of the device.
To Next Page
Loading...
Need help?
General
