OMICRON 167
CT Analyzer Suite
11 CT Analyzer Suite
The CT Analyzer Suite software enables complete remote control of CT Analyzer test sets from a
computer. For detailed information about the CT Analyzer Suite software, please refer to the
CT Analyzer Suite help.
11.1 System requirements
CT Analyzer Suite is exclusively intended for operation with CT Analyzer test sets equipped with
firmware version 5.00 or later.
CT Analyzer Suite requires one of the following operating systems installed on your computer:
Windows 7 32 bit or 64 bit, Windows 8 64 bit, Windows 8.1 64 bit, Windows 10 32 bit or 64 bit.
11.2 Installing CT Analyzer Suite
The CT Analyzer Suite software and its installation program Setup Wizard are included on the
CT Analyzer Suite CD ROM accompanying CT Analyzer. Proceed as follows to install
CT Analyzer Suite:
1. Exit all other major programs running on your computer.
2. Insert the CT Analyzer Suite CD ROM into your computer’s CD ROM drive. The Setup Wizard starts
automatically.
Note: Should the Setup Wizard not start automatically a few seconds after the CD has been inserted
into the CD ROM drive, change to the Windows Explorer and double-click setup.exe on the
CT Analyzer Suite CD ROM.
3. Follow the instructions displayed on the screen to install the software.
11.3 The CT Analyzer Suite home view
Launching CT Analyzer Suite opens the CT Analyzer Suite home view. The home view provides an
overview of all available features and functions. Clicking a button in the home view displays the
corresponding view or executes the specific function.
Press the F1 key on your keyboard or click the help button and select Help to display the help system
providing detailed information about CT Analyzer Suite.
The figure below shows the CT Analyzer Suite home view.
To Next Page
Loading...
Need help?
General
