OMICRON 75
Operating and configuring CT Analyzer
6.9.3 Update firmware
Note: Instead of using the Update Firmware function of the CT Analyzer you can
also use the Device Update function of the CT Analyzer Suite software. For
detailed information, please refer to the CT Analyzer Suite help.
Using this function you can install new device firmware.
Figure 6-13: File system card for selecting a new firmware file
To perform a firmware update, a corresponding firmware file CTAnalyzer.bin has to be available in the
A:\OMICRON\ directory on the Compact Flash card.
To update the firmware, select the desired firmware file CTAnalyzer.bin using the cursor keys
and press the Update Firmw. soft key.
Note: The firmware update process may take some minutes. If the update process is interrupted or fails,
switch the CT Analyzer test set off and on again. The device then tries to perform the firmware update
again automatically.
Press Abort to return to the Tools Menu page without updating the firmware.
Note:
It is also possible to install older firmware. In this case, the user interface text is deleted and the device
automatically changes to the English user interface. After you have downgraded the firmware, you also
have to install the user interface language file of this (older) firmware package.
After the installation of new firmware, the user interface language automatically changes to English if
the installed user interface text is no longer compatible. If you are using a user interface language other
than English, install the corresponding new user interface language file delivered with the new firmware.
Press the Main soft key in
any test card
Main Menu:
- Tools
Select soft key
Tools Menu:
- Update Firmware
-> File system card
How to get there:
To Next Page
Loading...
Need help?
General
