CT Analyzer User Manual
66 OMICRON
6.8 Settings
In the Setting Menu page you can access the device settings and the default
settings for new CT tests. Select an entry using the cursor keys and then
press the Select soft key to open the corresponding settings page.
Figure 6-7: Setting Menu page
6.8.1 Available options in the Setting Menu page
Table 6-1: Setting Menu options
Option Description
Select Language Selection of the user interface language.
One user language can be installed on CT Analyzer. The English user
interface is part of the firmware and therefore always available. The
second language can be installed by the user as required (refer to section
6.9 on page 73).
Select Startup Mode Using this option you can select the default test mode CT Analyzer comes
up each time when it is switched on.
Test at Startup: Select the default test mode using the soft keys CT Test,
Adv. CT Test or Quick.
Mode at Startup: Select the default test mode using the soft keys
Single Ratio or Multi-Ratio.
More detailed information:
→ CT Test mode, see chapter 7 on page 80.
→ Advanced CT Test mode, see chapter 8 on page 89.
→ Quick Test measurement function, see chapter 10 on page 142
→ Multi-ratio testing with CT SB2 switch box, see CT SB2 User Manual.
Default Test Card
Selection
Select the test cards a new Advanced CT test should contain by default.
Please refer to section 6.8.2 on page 70.
Press the Main soft key in
any test card
Main Menu:
- Settings
Select soft key
-> Setting Menu page
How to get there:
To Next Page
Loading...
Need help?
General
