121
Using Copy Mode Section 6-5
7. Press the Level Key for at least one second to start the download.
“DOWN” will flash on the display during the download. The mode will return auto-
matically to operating mode when the download has been completed.
8. Repeat steps 4 to 7 to continue copying the data.
The following example shows copying data to unit number 3.
Turn OFF the power and change unit number 1 back to unit number 2.
Change unit number 3, where the data is to be downloaded, to unit number
1. The system configuration is shown in the following diagram. Turn ON the
power and follow steps 4 to 7 to copy data to unit number 3.
9. After copying is completed, turn OFF the power and change the unit num-
bers. In this example, turn OFF the power and change unit number 5 to unit
number 1, and change unit number 1 to unit number 3.
UNIT
COPY
CH
MasterE5ZN-SDL
UNIT
COPY
CH
E5ZN E5ZN E5ZN
521
Copy destination
Copy source
To Next Page
Loading...
