Omron E5ZN - Page 137

123
List of Parameters Section 6-6
Power ON
Adjustment levelOperation level
Protect Level
Copy Mode
Copy Key
1 second min.
Level Key for less than 1 second
Automatic return
or COPY Key for
1 second or less
To top of operation level
PV AT Execute/Cancel
Operation/Adjustment
Protection
1 second min.
3 seconds min.
Cooling Coefficient
Control in progress
Control stopped
Level + Mode Keys
1 second min.
Level + Mode Keys
3 seconds min.
Level Key for less than 1 second
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Mode Key
Communications Writing
Heater Current Value
Monitor
Heater Burnout Detection
Initial Setting/
Communications
Protection
Setting Change
Protection
PV/SP
Multi-SP
(Set Point 0 to 1)
Ramp SP Value
Monitor
Heater Current Value
Monitor
RUN/STOP
Alarm Value 1
Alarm Upper Limit
Value 1
Alarm Lower Limit
Value 1
Alarm Value 2
Alarm Upper Limit
Value 2
Alarm Lower Limit
Value 2
Alarm Value 3
MV Monitor for Heating
MV Monitor for Cooling
To top of adjustment level
Set Point 0
Set Point 1
Temperature Input Shift
Upper Limit Temperature
Input Shift Value
Lower Limit Temperature
Input Shift Value
Proportional Band
Integral Time
Derivative Time
Dead Band
Manual Reset Value
Heating Hysteresis
Cooling Hysteresis
(See note 1.)
(See note 1.)
(See note 1.)
Note Indicates parameters that are displayed for pulse output models only.