1.1.3 Range of use
The MP2000-X compactor is designed for compressing soft organic materials to bales wrapped in plastic
film for storage or transport. The compactor must only be used for this purpose.
NOTE: Other materials can also be compressed, but have to be confirmed by Orkel AS in each case. This due to
warranty legislations.
1.2 CONTROL BEFORE DELIVERY
This machine is tested, controlled and has passed final inspection, before leaving the factory.
1.2.1 Preparation at customer location
Orkel AS will set-up the machine for the customer if requested/agreed. An introduction course, both in
handling and operating the compactor will be held at site if requested/agreed. During commissioning and
start-up period, we’re offering our technical assistance and answering all questions regarding the com-
pactor start-up.
NOTE: Please see the delivery - warranty formula in section 1.1 "Forms and reports"
1.3 IDENTIFICATION OF THE MACHINE
A sticker describing the serial number is located on the right side of the machine. In addition, the number
is also imprinted on top of the frame. See Figure 1.1.
The serial number must always be provided when contacting your dealer, either it’s for ordering parts or
technical assistance.
The serial number is the safest way to identify your machine. Do not remove or change the serial number.
Figure 1.1 :
Serial number location
1 GENERAL 12
To Next Page
Loading...