ORKEL MP2000-X - Safety; Before Maintenance; Safety Precautions During Maintenance and Mechanical Adjustments

7.10.2 Adjusting the wrapping table belt 82
7.11 Frame, drawbar, attachments 84
7.11.1 Frame 84
7.11.2 Main components, fastening points 84
7.12 Chamber roller bushings 84
7.12.1 Wear inspection 84
7.12.2 Permissible wear 85
7.12.3 Remove sprockets 86
7.13 Hydraulics 87
7.13.1 Hydraulics oil 87
7.13.2 Hoses and connections 87
7.13.3 Hydraulic pump, gearbox 87
7.13.4 Heat exchanger 88
7.14 Oil change and oil filter 88
7.14.1 Changing oil and filter 89
7.15 Welding and grinding 90
7.15.1 Precautions when welding 90
7.16 Service history 91
7.1 SAFETY
7.1.1 Before maintenance
Before any maintenance or adjustments are performed on the machine, we recommend you to make a con-
ference call to your local dealer or Orkel AS. All repair work shall be carried out by a skilled mechanic.
7.1.2 Safety precautions during maintenance and mechanical adjustments
NOTE: Due to your own safety, Orkel AS recommends that all repair- and maintenance work on the machine is
done in daylight conditions or equivalent.
If you fail to comply with instructions given it could result in personal injury or loss of life.
l The PTO/Tractor must be stopped before any repair work or maintenance is carried out.
l The hydraulic safety valves on the chamber door lifting cylinders [K2 and K3], must be closed before
anyone enters the chamber.
7 MAINTENANCE AND MECHANICAL ADJUSTMENTS 66