l Check the road lights and work lights
l Check the emergency buttons for malfunction.
7.2.1 Fuses
The machine is equipped with one fuse unit inside the electrical cabinet. See section 10.2 "Electrical cab-
inet power supply rail"
7.3 WHEELS
Check the condition of the tires, they should have sufficient pattern depth and be without excessive wear.
Control the tire inflation and wheel nut torque before transport to a new location. See section 12.5
"Wheels and tyres"
7.4 CHAINS
The chamber chains, and chain tensioner A, B and C, must be controlled for sufficient lubrication and cor-
rect tension. Look for abnormal wear and tear on sprockets and chains. Replace worn out parts if needed.
Contact your local supplier or Orkel AS directly if you have any doubts about parts that must be replaced.
7.4.1 Chain tensioner A
Basic setting:
Adjust the chamber drive chain tensioner bolt until the chain play is approximately 3 mm.
Figure 7.1 :
Chain tensioner A
7 MAINTENANCE AND MECHANICAL ADJUSTMENTS 68
To Next Page
Loading...