Oil type Motor oil SAE 10W - 30, 15W - 40
Oil consumption 6ml each bale on the table. 0.3 l/h (@ 50 bales/h)
Volume container 4,2 l
12.4 HYDRAULIC SYSTEM
Chamber drive: 280/340 bar (SW/relief valve)
Sub-conveyer, feed hopper and film system: 180 bar
Elevator and chamber door: 170 bar
Wrapper 150 bar
F25 additional pump (flip and feed hopper): 190 bar
12.5 WHEELS AND TYRES
Tyre dimension: 385/65 R 22,5
Rim dimension: 11,75 x 22,5, 10-bolt
Inflation pressure: 8,0 bar / 800 kPa / 116 psi (lb/in²) Wheel nuts torque: 8,0 bar / 800 kPa / 116 psi (lb/in²)
Wheel nuts torque: 450 Nm
12.6 DIMENSIONS AND WEIGHT
12.6.1 Measurements
Net weight (F10, telescopic drawbar): 9660 kg
Allowed total weight: 12500 kg
Allowed vertical load on drawbar: 2500 kg
Height (F10, telescopic drawbar), transport mode: 4100 mm
Height (F10, telescopic drawbar), operating mode: 3900 mm
Length (F10, telescopic drawbar), transport mode: 8740 mm
Length (F10, telescopic drawbar), operating mode: 10770 mm
Width (F10, telescopic drawbar), transport mode: 2550 mm
Width (F10, telescopic drawbar), operating mode: 3710 mm
Chamber size: Width 1200 mm x Diameter 1150 mm
Bale volume 1,25 m³
Feed hopper volume: 25 m³ (F25) / 10 m³ (F10)
12.6.2 Power requirements
120hp / 90 kW (diesel engine)
90hp / 75 kW (electric motor)
12 SPECIFICATIONS 131
To Next Page
Loading...