l Be cautious when cleaning belts and rollers to avoid crushing or squeezing of body parts.
l Use proper shoes and work wear to avoid slipping and other injuries when working on the machine.
7.1.3 Elements of hazard during maintenance
If you fail to comply with instructions given it could result in personal injury or loss of life
l Squeezing/crushing of fingers and hands near chains and sprockets
l Squeezing/crushing of finger and hands during cleaning of conveyor belts and rollers.
l Getting entangled into PTO axle. Do not stay in PTO area.
l Slipping and falling while entering the stairs or when working on the machine.
l Getting moderate burns. The oil is approximately 70°C - 158°F.
IMPORTANT: Safeguard can only be dismounted when the machine is stopped.
7.1.4 Control after repair or maintenance
Check that all tools are stowed away and that all covers are mounted correctly and in place.
Shut down the machine and disconnect the PTO-shaft prior to every machine
inspection.
Be extra careful when performing function control on running machinery.
IMPORTANT: Inspections, simple repairs and adjustments mentioned in this manual may be performed by oper-
ators who have undergone training in the use and maintenance of this machine. More advanced repairs must
be performed by skilled technicians.
NOTE: Maintenance should begin with a thorough cleaning in order to avoid dirt penetrating unwanted areas/-
components.
7.2 ELECTRICS
l Visually, check the cables for damages and proper placement.
l Check all cable connections
7 MAINTENANCE AND MECHANICAL ADJUSTMENTS 67
To Next Page
Loading...