14-19
Address
FP0 T32
FP0 C10,
C14, C16,
C32, SL1
Name Descriptions
-
DT9020
(Availabl
e type:
SL1)
S-LINK status
flag/error flag
Notes
- ERR1 and ERR3 occur even if the power
supply on the S-LINK side is interrupted, but are
canceled when the power supply is turned on
again.
- ERR4 is held. To cancel it, repair the
disconnected wire in the S-LINK syste, or
whatever iscausing the problem, and then either
turn the power to the FP0 on again, press the
SET switch to reset it, or turn the power supply
on again on the S-LINK unit side.
To Next Page
Loading...
