14-125
Error
code
Name
Opera-
tion
status
Description and steps to take
FP0
FP-e
FPΣ
FP-X
FP1/FP-M
FP2
FP2SH
FP10SH
FP3
E6
Compile
memory
full error
Stops
The program is too large to compile in
the program memory.
⇒ Change to PROG. mode and reduce
the total number of steps for the
program.
-FP10SH
If memory expansion is
possible,compilation will become
possible when the memory is expanded.
AAAA A A A
E7
High-level
instruction
type error
Stops
In the program, high-level instructions,
which execute in every scan and at the
leading edge of the trigger, are
programmed to be triggered by one
contact. (e.g. F0 (MV) and P0 (PMV) are
programmed using the same trigger
continuously.)
⇒ Correct the program so that the high-
level instructions executed in every scan
and only at the leading edge are
triggered separately.
A A A A A A
E8
High-level
instruction
operand
combina-
tion error
Stops
There is an incorrect operand in an
instruction which requires a specific
combination operands (for example, the
operands must all be of a certain type).
⇒ Enter the correct combination of
operands.
AAAA A A A A A
E9
No
program
error
Stops
Program may be damaged.
⇒Try to send the program again.
A A
E10
Rewrite
during
RUN
syntax
error
Conti-
nues
When inputting with the programming
tool software,a delection,addition or
change of order of an
instruction(ED,LBL,SUB,RET,INT,IRET,
SSTP,and STPE) that cannot perform a
rewrite during RUN is being attempted.
Nothing is written to the CPU.
A A A A
A:Available
To Next Page
Loading...
