Perkins Phaser Series - Page 257

20E FUEL SYSTEM
To remove and to fit
- Stanadyne pump20E-06
Special tools:
Gear puller, PD.155C
Adaptors for use with PD.155C, PD.155B-5
To remove
1 Remove the fuel pipes, disconnect the electrical
stop control and the control rod of the fuel injection
pump.
2 Remove the gear cover from the cover of the
timing case. Remove the gear nut and the spring
washer.
3 Release the flange nuts of the fuel pump.
4 Loosen the drive gear of the fuel injection pump
with the puller PD.155C (A1) and the adaptors
PD.155B-5 (A2).
5 Remove the fuel injection pump.
a a a
a
a
a
a
a
a
a a a
1
a a a
a
a
a
a
a
a
a a a
2
PA162
20E.02 Perkins Phaser/1000 Series, April 1995