14 CRANKSHAFT ASSEMBLY
To remove and to fit the bushes for the
balance weights14A-14
1 Press the bushes out of the balancer frame and
the rear cover with a suitable adaptor.
2 Clean the parent bores and lubricate them with
clean engine lubricating oil.
3 Make a suitable adaptor to the dimensions given
in (A3). Fit a bush onto the adaptor. Press the bush
(B4) into the parent bore in the rear of the balancer
frame (B3), in a continuous movement, until the
shoulder of the adaptor is against the rear face of
the balancer frame. In this position the rear face of
the bush should be 3,25/3,30 mm (0.128/0.130 in)
from the rear face of the balancer frame (B).
Repeat this operation for the other bush.
4 Fit a bush (B1) onto the adaptor and put it into
position at the front end of one of the parent bores
in the rear cover (B2). Press in the bush, in a
continuous movement, until the shoulder of the
adaptor is against the front face of the rear cover.
In this position the front face of the bush should be
3,25/3,30 mm (0.128/0.130 in) from the front face
of the rear cover (B). Repeat this operation for the
other bush.
a
a
a
a
a
a
3,25/
3,30
31,70
a
a
a
37,84
a
42
a
a
a
50,8
a
a
a
a
28,45
a
a
a
34,3
a
a
a
a
a
a
17,0/17,8
2,5/3,0
a
a
23,5
a
27
a
a
a
29,26
a
a
a
a
a
130/131
a
38
PA118
a
a
a
a
a
a
a
a
a
a
MILLIMETRES
1
a
a
3
2
a
38
1
a
a
3
4
PA119
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
0,19/0,40mm
(0.007/0.016in)
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
3,25/3,30mm
(0.128/0.130in)
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
a
3,25/3,30mm (0.128/0.130in)
2
14A.30 Perkins Phaser/1000 Series, April 1995
To Next Page
Loading...
