10 GENERAL INFORMATION
Introduction
This workshop manual has been designed to
provide assistance in the service and overhaul of
Perkins Phaser and 1000 Series engines.
Most of the general information which is
included in the relevant User's Handbook
(sections 1 to 9) has not been repeated in this
workshop manual and the two publications
should be used together.
Where the information applies only to certain engine
types, this is indicated in the text.
The details of some operations will be different
according to the type of fuel injection pump which
is fitted. The specific pump type used can be found
by reference to the manufacturer's identification
plate on the pump body but, generally, the type of
pump fitted is as shown below.
Lucas DPA, DPS and DP200 Series
Bosch EPVE and MW
Stanadyne DB2 and DB4
When reference is made to the "left" or "right" side
of the engine, this is as seen from the flywheel end
of the engine.
Special tools have been made available and a list of
these is given in section 25. Reference to the
relevant special tools is also made at the beginning
of each operation.
Data and dimensions are included at the end of
each section.
Read and remember the "Safety precautions".
They are given for your protection and must be
used at all times.
Danger is indicated in the text by two methods:
Warning! This indicates that there is a possible
danger to the person.
Caution: This indicates that there is a possible
danger to the engine.
Note: Is used where the information is important,
but there is not a danger.
10.02 Perkins Phaser/1000 Series, April 1995
To Next Page
Loading...
