Perkins Phaser Series - To Inspect

CYLINDER BLOCK ASSEMBLY 16
To inspect16A-02
1 Clean the passages for the coolant and for the
oil.
2 Check the cylinder block for cracks and for other
damage.
3 The top face of the cylinder block must not be
machined as this will affect the liner flange depth
and the piston height above the top face of the
cylinder block.
4 Check the camshaft bush for wear. If the bush is
to be renewed, use a suitable adaptor to press it
out of the bore. Ensure that the lubricating oil hole
in the new bush will be towards the front of the
engine, when fitted. Press in the bush with the oil
hole on the same side and aligned with the oil hole
in the block until the front end of the bush is
aligned with the face of the recess.
Perkins Phaser/1000 Series, April 1995 16A.05