PIAGGIO Beverly 500 i.e. - Page 269

- Insert the pumping member guiding bushing at
the bottom end of the stem.
- Insert the stem into the casing being careful not to let the guiding bushing come out of the stem.
- Move the oil guard in abutment using a tube.
TUBE SIZE
Specification Desc./Quantity
Inside: 44 mm
Outside: 51 mm
Height: approx. 105 mm
- Insert the contrast spring into the pumping mem-
ber.
- Insert the pumping member into the stem.
- Insert the stem into the fork leg being careful not
to let the guiding bushing come out of the stem.
- Insert and screw the pumping member screw with
a new copper washer and tighten to the prescribed
torque.
CAUTION
TO PREVENT THE PUMPING MEMBER ROTATION, IN-
SERT AN INSIDE 22 MM HEXAGON WRENCH INTO THE
STEM.
Locking torques (N*m)
Pumping element fixing screw 25 - 35
- Pour recommended oil into the stem.
Recommended products
AGIP FORK 7,5W Oil for front fork
Hydraulic oil SAE 7,5W
Beverly 500 i.e. Suspensions
SUSP - 269