7 General
Installation manual for PMC tendo DD5/PMCprimo Drive3 Page 23
7.7.8 LED display
7.7.8.1 PMCtendo DD5
A 3-character LED display indicates the status of the amplifier after switching on the 24V supply
( p.94).
When the keys on the front panel are used, the parameter and function numbers are shown, as
well as the numbers for any errors that may occur ( p.98).
7.7.8.2 PMCprimo Drive3
A 3-character LED displays the servo amplifiers firmware version after switching on the 24V
supply for two seconds (e.g. “5.18”).
Afterwards the status of up to 10 axes is shown (or just “run”). ( p.101).
When an error occurs the error number is displayed ( p.100).
To Next Page
Loading...
