Pilz PMC Series User Manual

9 Interfaces
Installation manual for PMC tendo DD5/PMCprimo Drive3 Page 55
9.6.7 Sine Encoder without data channel (X1)
An sine-cosine encoder without data channel can be used as standard motor feedback. Select
feedback type 7 "SinCos 5V with W&S". Drive executes wake&shake to calculate the necessary
start-up information for the position controller every time the 24V auxiliary voltage is switched
on.
The thermostat contact in the motor is connected via the encoder cable to X1 and evaluated
there.
If lead lengths of more than 50m are planned, please consult our customer service.
Frequency limit: 350 kHz
Don't use this feedback type with vertical load (hanging load).

Pilz PMC Series Specifications

General

Brand	Pilz
Model	PMC Series
Category	Industrial Equipment
Language	English