POLYSONICS DCT-7088 User Manual

Appendix C
A-106
18. Enter 4088.EXE and press
ENTER
.
The following is displayed:
UPLOAD 4088.EXE ASCII OR XMODEM (A OR X):
19. Press
X
for XMODEM. (Do not press
ENTER
.)
The following message is displayed:
UPLOADING 4088.EXE
XXXXX BYTES, XXX BLOCK(S)
TRANSFER TIME: X MIN X SEC
NOTE:
If a DDF3088 is used, the LCD cannot display the entire message due to space
limitations.
After a few seconds the transfer begins, as indicated by a series of Ts. A message is
displayed indicating when the transfer is complete.
20. Enter 4088 on the PC and press
ENTER
to run the new software on the flowmeter.
(While the flowmeter is initializing, the new software version number momentarily
appears on the flowmeter's display.)
IMPORTANT:
Verify that the software on the flowmeter is running properly before
proceeding to the next step.
21. Enter TRANSFER -R STARTUP.BAT and press
ENTER
.
The message RECEIVING STARTUP.BAT
...
is displayed indicating that the B: drive
is ready to receive the file. Do not wait for the file to be received, but go immediately to
the next step.
22. Press the
PgUp
key.
The following is displayed:
UPLOAD WHICH FILE:
23. Enter STARTUP.BAT and press
ENTER
.
The following is displayed:
UPLOAD STARTUP.BAT ASCII OR XMODEM (A OR X):
24. Press
X
for XMODEM. (Do not press
ENTER
.)
The following message is displayed:
UPLOADING STARTUP.BAT
XXXXX BYTES, XXX BLOCK(S)
TRANSFER TIME: X MIN X SEC
After a few seconds the transfer begins, as indicated by a series of Ts. A message is
displayed indicating when the transfer is complete.

POLYSONICS DCT-7088 Specifications

General

Brand	POLYSONICS
Model	DCT-7088
Category	Measuring Instruments
Language	English